Epson Stylus Pro 4450 - Ink Discharge

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Basic Adjustment 411
5.3.18 Ink Discharge
Before removing the Damper (Valve Assy., Head), discharge the ink remaining
in the equipment by following the procedure below.
 Procedure
1. Turn the printer power on.
2. Start up the adjustment program and select [Ink Discharge].
3. Click the [Run] tab.
4. When a pop-up window appears, click [OK].
5. Confirm that the "Please Remove Ink" message is displayed on the
LCD, and pick up the ink levers on both sides to remove all the ink
cartridges.
6. Press "Menu(>)" to display "Set Lever (L/R)", and lower the ink
levers.
7. Press "Menu(>)" to change the display to "Dischg. Washfluid". The
ink discharge begins at this time.
8. The display turns to "Set Cleaning I/C" when the ink discharge is
finished. Pull up the ink levers on both sides to install the ink
cartridges.
9. Press "Menu(>)" to display "Set Lever (L/R)", and lower the ink
levers.
10. Press "Menu(>)" to start the head cleaning. The display changes to
"Head Cleaning".
11. The display turns to "Please Remove CL I/C" when the head cleaning
is completed. Pull up the ink levers on both sides to remove the ink
cartridges.
12. Press "Menu(>)" to display "Set Lever (L/R)", and lower the ink
levers.
13. Press "Menu(>)" to discharge the cleaning liquid. The display changes
to "Dischg. Washfluid".
14. Click [Finish] on the Ink Discharge screen when the discharge is
finished.
Figure 5-56. Ink Discharge