EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 249
7. Hold the front panel section at the front of the printer, lift the printer upward,
and insert the right tab of the "Joint Plate" into the slit of the "Base, Right".
Figure 4-57. "Joint Plate" Attachment
C A U T I O N
When lifting the printer in the steps given below, pay
attention to the followings:
Hold the front panel section of the printer. Holding other
section could cause the malfunction of the printer.
This printer is heavy (approximately 40 kg). Hold the
front panel section at the front of the printer securely
and make sure that the grip is solid before lifting the
printer. Dropping the printer may cause injury or
malfunction of the printer.
Take care not to get your hand sandwiched when you
lower the printer.
To Next Page
Loading...
