CONFIDENTIAL
Paper roll Panel button command ESC c 5
Ver. 10.01 p. 156
ESC c 5
SETTING COMMAND
[Name] Enable/disable panel buttons
[Format] ASCII ESC c 5
n
Hex 1B 63 35
n
Decimal 279953
n
[Range] 0 ≤
n
≤ 255
[Default]
n
= 0
[Printers not featuring this command] None
[Description] Enables or disables the panel buttons.
• When the LSB of
n
is 0, all buttons are enabled.
• When the LSB of
n
is 1, all buttons are disabled.
[Notes]
■ If panel buttons are disabled, the function of the panel button, such as feeding, will be executed when the
panel button is turned on.
■ When the printer cover is open, there are buttons that are always enabled or disabled regardless of this
command. The buttons are different, depending on the printer model.
■ Even if the panel buttons are disabled by this command, paper feed button will be enabled temporarily
while printer is waiting for the buttons to be pressed in the following states. Whether the paper can be
fed or not depends on the state:
• When a new roll paper is installed in the TM-U230 or TM-U210 (see GS z 0 to determine if paper
can be fed or not)
• When the printer is waiting for the button to be pressed while GS ^ is executed (but paper cannot be
fed)
• When the printer is waiting for the button to be pressed while GS FF is executed (but paper cannot be
fed)
■ To prevent problems caused by accidentally pressing the buttons, use this command to disable the buttons.
Panel button command
To Next Page
Loading...
Need help?
General