Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Print position commands GS T
Ver. 10.01 p. 187
GS T
EXECUTING COMMAND
[Name] Set print position to the beginning of print line
[Format] ASCII GS T n
Hex 1D 54 n
Decimal 29 84 n
[Range] n = 0, 1, 48, 49
[Default] None
[Printers not featuring this command] TM-T88III, TM-L60II, TM-P60, TM-U230, TM-U220, TM-U210, TM-U300A/B
[Description] In standard mode, moves the print position to the beginning of the print line after performing the operation
specified by n .
[Notes]
■ In page mode, this command is ignored.
■ This command is ignored if the print position is already the beginning of the line.
■ If the print position is not set to the beginning of the line, when n = 1, 49, this command functions the
same as LF.
■ Setting values of each command, definitions, and receive buffer content are not changed.
■ By processing this command, the print position moves to the left of the print area. The printer will be in
the beginning of the line and data will not be in the print buffer.
■ When using commands that are enabled only at the beginning of the line, these commands are sure to be
executed if GS T is used immediately before using those commands.
n Function
0, 48 Cancel data in the current print buffer
1, 49 Print data in the current print buffer
Print position commands

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English