CONFIDENTIAL
Paper roll Print commands FF (on label)
Ver. 10.01 p. 76
FF (on label)
EXECUTING COMMAND
[Name] Print and feed label to print starting position (on label)
[Format] ASCII FF
Hex 0C
Decimal 12
[Default] None
[Range] None
[Printers not featuring this command] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-P60, TM-U230, TM-U220,
TM-U210, TM-U300A/B
[Description] Prints the data in the print buffer and feeds paper to the print starting position on the next label.
[Recommended Functions]
This command is an obsolete command that is supported only by some printer models and may not be
supported by future models.
FS ( L is recommended for controlling labels. With the following procedure, that command can perform the
same as this command.
1. Using LF, the printer prints the last line of a label.
2. Using FS ( L <Function 67, (m = 49)>, execute the paper feed to the print start position of the next
label.
[Notes]
■ This command is enabled only when a label is selected in standard mode. Printer operation differs when
page mode is selected.
■ After printing, the print position moves to the beginning of the line. When a left margin is set, the
position of the left margin is the beginning of the line.
■ Method of specifying label paper differs, depending on the printer models.
Print commands
obsolete command
obsolete command
To Next Page
Loading...
Need help?
General