Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Two-dimension code commands GS ( k
Ver. 10.01 p. 535
GS ( k <Function 181>
[Name] QR Code: Print the symbol data in the symbol storage area
[Format] ASCII GS ( k pL pH cn fn m
Hex 1D 28 6B 03 00 31 51 m
Decimal 2940107 3 0 49 81 m
[Range] ( pL + pH × 256) = 3 ( pL = 3, pH = 0)
cn = 49
fn = 81
m = 48
[Description] Encodes and prints the QR Code symbol data in the symbol storage area using the process of <Function 180>.
[Notes]
■ In standard mode, use this function when printer is “at the beginning of a line,” or “there is no data in the
print buffer.”
■ The symbol size that exceeds the print area cannot be printed.
■ If there is any error described below in the data of the symbol storage area, it cannot be printed.
• There is no data (Function 180 is not processed).
• If the data of the symbol storage area is more than the data allowed by specified model and data
compaction mode. (This case is an abnormal number of data.)
• The four data compaction modes are listed below (in order of compaction rate). Automatically selects
best compaction mode by the data of the symbol storage area.
– Numerical mode
– Alphanumeric mode
– Kanji mode
– 8-Bit Byte Mode
■ The following data are added automatically by the encode processing.
• Position Detection Patterns
• Separators for Position Detection Patterns
• Timing Patterns

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English