Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Customize commands GS ( C
Ver. 10.01 p. 561
GS ( C pL pH m fn b c1 c2 d1...dk <Function 1>
[Name] Store the data in the specified record
[Format] ASCII GS ( C pL pH m fn b c1 c2 d1...dk
Hex 1D 28 43 pL pH 00 fn 00 c1 c2 d1...dk
Decimal 294067 pL pH 0 fn 0 c1 c2 d1...dk
[Range] 6 ≤ ( pL + pH × 256) ≤ 65535 (0 ≤ pL ≤ 255, 0 ≤ pH ≤ 255)
m = 0
fn = 1, 49
b = 0
32 ≤ c1 ≤ 126
32 ≤ c2 ≤ 126
32 ≤ d ≤ 254
k = ( pL + pH × 256)−5
[Description] Stores the data ( d1... dk ) as the record specified by the key codes ( c1 , c2 ) in the NV user memory.
• When the specified record already exists, the data is overwritten.
• A terminator is automatically assigned.
[Notes]
■ In standard mode, this command is valid only at the beginning of the line.
■ You cannot include macros with this command, so do not use this command while defining macros.
■ You cannot use this command when the NV user memory does not have enough capacity to store the
specified records. The available capacity is confirmed by Function 4.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-L90, TM-P60, TM-U220
TM-J2000/J2100
This function uses the “data quantity ( k ) + number of control information data (3 byte)” area for
execution.
TM-T90
This function uses the “data quantity (
k ) + number of control information data (3 byte)” area for
execution.

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English