Epson TM-T88III

CONFIDENTIAL
Paper roll Status commands ESC u
Ver. 10.01 p. 313
ESC u
EXECUTING COMMAND
[Name] Transmit peripheral device status
[Format] ASCII ESC u n
Hex 1B 75 n
Decimal 27 117 n
[Range] TM-U220, TM-L60II: n = 0, 48
TM-U300A/B: n = 0
[Printers not featuring this command] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-P60, TM-U230, TM-U210
[Description] Transmits the peripheral device status as 1 byte of data.
[Recommended Functions]
This command is supported only by some printer models but will not be supported by future models.
It is recommended to use GS r 2 to check the status and GS r to transmit the peripheral device status.
[Notes]
■ ESC u is not a recommended command. ESC u will not be included in future products.
■ The peripheral device status to be transmitted is as follows:
[Model-dependent variations] TM-U300A/B
TM-U300A/B
This command is available with the serial interface.
Bit Binary Hex Decimal Status
0 0 00 0 Drawer kick-out connector pin 3 is LOW.
... how to use
this table
1 01 1 Drawer kick-out connector pin 3 is HIGH.
1-3 — — — Undefined.
4 0 00 0 Not used. Fixed to Off.
5, 6 — — — Undefined.
7 0 00 0 Not used. Fixed to Off.
Program Example for all printers
PRINT #1,CHR$(&h1B);"u";CHR$(0);
Status commands
obsolete command
obsolete command