Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Printing paper commands FS ( L
Ver. 10.01 p. 653
FS ( L <Function 65 >
[Name] Feed paper to the label peeling position
[Format] ASCII FS ( L pL pH fn m
Hex 1C284C020041 m
Decimal 28 40 76 2 0 65 m
[Range] ( pL + pH × 256) = 2 ( pL = 2, pH = 0)
m = 48, 49
fn = 65
[Description] Feeds paper to the label peeling position.
[Notes]
■ Please use this function by using “the first state of the line” in standard mode.
■ This function is used only with label paper.
■ The paper feed operation ends when no paper is detected in the paper feed to the label peeling position.
■ [Position information A] transmitted by Function 48 becomes (bit 0 = 1) when this function is processed.
Moreover, the print area of the label paper or black mark paper if there is a print start position right under
label peeling position becomes “current label.”
■ “Label peeling position” is the position where the label can be peeled off by hand. Details are different
depending on the model.
[Model-dependent variations] TM-L90
m Function
48 Feeds paper to the label peeling position. However, if the paper is in standby at the
label peeling position, the printer does not feed.
49 Feeds paper to the label peeling position. However, if the paper is in standby at the
label peeling position, the printer feeds paper to the next label peeling position.

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English