Epson TM-T88III

CONFIDENTIAL
Paper roll Bit-image commands ESC *
Ver. 10.01 p. 195
ESC
*
EXECUTING COMMAND
[Name] Select bit-image mode
[Format] ASCII ESC ✻ m nL nH d1 ... dk
Hex 1B 2A m nL nH d1 ... dk
Decimal 27 42 m nL nH d1 ... dk
[Range] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-L60II:
m = 0, 1, 32, 33
0 ≤ nL ≤ 255
0 ≤ nH ≤ 3
0 ≤ d ≤ 255
k = nL + nH × 256 [in case of m = 0, 1]
k = ( nL + nH × 256) × 3 [in case of m = 32, 33]
TM-U230, TM-U220, TM-U210, TM-U300A/B:
m = 0, 1
0 ≤ nL ≤ 255
0 ≤ nH ≤ 3
0 ≤ d ≤ 255
k = nL + nH × 256
[Default] None
[Printers not featuring this command] TM-P60
[Description] Stores the bit image data in the print buffer using the mode specified by m as follows:
m Mode
Number of bits for
vertical data Dot density in horizontal Amount of data ( k )
0 8-dot single-density 8 Single-density nL + nH × 256
1 8-dot double-density 8 Double-density nL + nH × 256
32 24-dot single-density 24 Single-density ( nL + nH × 256) × 3
33 24-dot double-density 24 Double-density (
nL + nH × 256) × 3
Bit-image commands