CONFIDENTIAL
Paper roll Miscellaneous commands GS A
Ver. 10.01 p. 452
GS A
EXECUTING + SETTING
[Name] Adjust label print starting position
[Format] ASCII GS A
mn
Hex 1D 41
mn
Decimal 29 65
mn
[Range] 0 ≤
m
≤ 255, 0 ≤
n
≤ 255
[Default]
m
= 0,
n
= 0
[Printers not featuring this command] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-P60, TM-U230, TM-U220,
TM-U210, TM-U300A/B
[Description] Adjusts the label print starting position in a selected direction and by a specified amount from the default
position.
•
m
specifies the adjustment direction as follows:
When the LSB of
m
is 0, the label position is adjusted in the normal direction.
When the LSB of
m
is 1, the label position is adjusted in the reverse direction.
•
n
specifies the adjustment amount as (
n
× vertical motion unit).
[Recommended Functions]
This command is supported only by some printer models and may not be supported by future models.
GS ( E is recommended for adjusting the label print starting position. GS ( E <Function 49> can perform the
same function as this command.
[Notes]
■ This command is effective only when label is selected, and it is received just after feeding a label to the
print starting position in the condition shown below:
• When resetting the printer or turning on the power.
• Just after executing FF, GS FF, GS <, or GS A.
• Just after performing paper feed by pressing the paper feed button
■ When calculating the adjustment amount, the vertical motion unit (
y
) is used.
■ When executing this command, the paper is fed to adjust the print starting position of the current label.
Miscellaneous commands
obsolete command
obsolete command
To Next Page
Loading...
Need help?
General