Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Miscellaneous commands ESC @
Ver. 10.01 p. 410
ESC @
EXECUTING + SETTING
[Name] Initialize printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
[Range] None
[Default] None
[Printers not featuring this command] None
[Description] Clears the data in the print buffer and resets the printer modes to the modes that were in effect when the
power was turned on.
• Any macro definitions are not cleared.
• Offline response selection is not cleared.
• GS A settings are not cleared.
• Contents of user NV memory are not cleared.
• NV graphics (NV bit image) and NV user memory are not cleared.
• The maintenance counter value is not affected by this command.
• The specifying of offline response isn’t cleared.
[Notes]
■ The DIP switch settings are not checked again.
■ The data in the receive buffer is not cleared.
■ When this command is processed in page mode, the printer deletes the data in the print areas, initializes
all settings, and selects standard mode.
■ This command can cancel all the settings, such as print mode and line feed, at the same time.
■ The print position moves to the beginning of the line when this command is executed. When a left margin
is set in standard mode, the position of the left margin is the beginning of the line or there is no data in
the print buffer.
Miscellaneous commands

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English