CONFIDENTIAL
Paper roll Miscellaneous commands GS z 0
Ver. 10.01 p. 481
GS z 0
SETTING COMMAND
[Name] Set online recovery wait time
[Format] ASCII GS z 0
t1 t2
Hex 1D7A30
t1 t2
Decimal 29 122 48
t1 t2
[Range] 0 ≤
t1
≤ 255
0 ≤
t2
≤ 255
[Default]
t1
= 6,
t2
= 0
[Printers not featuring this command] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-P60, TM-L60II,
TM-U300A/B, TM-U220
[Description] Sets the online recovery wait time from the time a new roll paper is installed to when the printer goes online.
• This command sets the paper wait time to (
t1
× 500 msec). When
t1
= 0, the paper wait time is set to 0.
• This command sets the recovery confirmation time to (
t2
× 500 msec). When
t2
= 0, the recovery
confirmation time is canceled.
[Notes]
■ The printer is in the paper wait time status after loading the paper. During this time, the printer performs
the following:
• The paper out LED is off.
• Paper can be fed by pressing the paper feed button.
• The printer is in the recovery confirmation time after the paper wait time (
t1
× 500 msec) has elapsed.
■ During paper wait time, the printer can be set online by DLE ENQ 0.
■ When the paper wait time is set to 0 (
t1
= 0), the printer is in the recovery confirmation status immediately
after the paper loading.
Miscellaneous commands
To Next Page
Loading...
