EasyManuals Logo

Epson TM-T88III Programming Guide

Epson TM-T88III
679 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #453 background imageLoading...
Page #453 background image
CONFIDENTIAL
Paper roll Miscellaneous commands GS A
Ver. 10.01 p. 453
The default and adjustment amounts for the print starting position differ, depending on the printer
model. A setting exceeding the maximum adjustment amount is set to the maximum adjustment amount.
Adjustment amounts when the print starting position is out of the label cannot be specified.
Selecting the label paper differs, depending on the printer model.
[Model-dependent variations] TM-L60II
TM-L60II
With a serial interface, the paper selection DIP switch is SW 2-6.
With a parallel interface, the paper selection DIP switch is SW 1-7.
The vertical motion unit is set by GS P.
The default print starting position is approximately 1.5 mm {0.06 inch} below the top edge of the
label.
The maximum adjustment amount in the paper feed direction is (label length – 1.5 mm {0.06 inch}
(top edge) – 1.5 mm {0.06 inch} (bottom edge) – 18 mm {255/360 inch}, and in the reverse direction
it is 0.5 mm {0.02 inch}.
Program Example
PRINT #1, CHR$(&H1D);"A";CHR$(0);CHR$(18);

Table of Contents

Other manuals for Epson TM-T88III

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson TM-T88III and is the answer not in the manual?

Epson TM-T88III Specifications

General IconGeneral
BrandEpson
ModelTM-T88III
CategoryPrinter
LanguageEnglish

Related product manuals