Epson TM-T88III

CONFIDENTIAL
Paper roll Bit-image commands ESC *
Ver. 10.01 p. 200
TM-T90
The modes selectable by m are as follows:
“Vertical” is in the direction of paper feeding and “horizontal” is perpendicular (at right angles)
to the direction of paper feeding.
See Functions 5 and 6 of GS ( E to specify the paper width.
When both standard mode and page mode are selected (a starting position specified by ESC T is
upper left or lower right).
[Other than Japanese model]
When the starting position specified by ESC T is lower right or upper left in page mode or
standard mode
When the starting position specified by ESC T is upper right or lower left in page mode.
90° or 270° rotated bit-image data will be printed.
dpi: dots per 25.4 mm (dots per inch)
m Mode
Vertical dot
density
Horizontal
Dot
density
Set adjacent
dots
Maximum number of dots
Paper width
80 mm
Paper width
60 mm
Paper width
58 mm
0 8-dot single-density 60 dpi 90 dpi Permitted 256 192 180
1 8-dot double-density 60 dpi 180 dpi Permitted 512 384 360
32 24-dot single-density 180 dpi 90 dpi Permitted 256 192 180
33 24-dot double-
density
180 dpi 180 dpi Permitted 512 384 360
m Mode
Vertical
Horizontal dot densityDot density Set adjacent dots Maximum number of dots
0 8-dot single-density 90 dpi Permitted 415 60 dpi
1 8-dot double-density 180 dpi Permitted 831 60 dpi
32 24-dot single-density 90 dpi Permitted 415 180 dpi
33 24-dot double-density 180 dpi Permitted 831 180 dpi