CONFIDENTIAL
Paper roll Bit-image commands GS ( L GS 8 L
Ver. 10.01 p. 271
❏ Specify left margin as 0, and the horizontal position to a position that is a multiple of 8.
(Example: the left margin = 0, horizontal position = 0, 8, 16, or 24 etc.)
❏ Specify the scaling to the original size (bx = 1, by = 1).
❏ Specify the size of image data not to exceed the current print area.
❏ A graphic that exceeds the size limit of (yL + yH × 256) can be printed by the repeated use of
the combination of this function and <Function 50> of this command. In that case, the
performance may be best when the vertical size is specified as [120 ≤ (yL + yH × 256) ≤ 400
(reference value)] by this function. However, the value is only a reference value. The most
suitable vertical size depends on the specifications of the PC or radio frequency energy
transmitted by wireless communication.
If the time of processing this function cannot be shortened when processing the above-mentioned
item, the printing result may include horizontal stripes. In this case, transmit the graphic data
specified within the maximum range of (yL + yH × 256) one time to prevent the horizontal stripe
but the performance will decrease.
The dot density and maximum print area are the same as Function 69. See the model information
of Function 69.
To Next Page
Loading...
Need help?
General