Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Bit-image commands GS ( L GS 8 L
Ver. 10.01 p. 274
■ The relationship between graphics data (column format) and print results is shown in the table below.
■ This printer is equipped with a print head configured in column format, which makes it faster to define
data using this function (column format) than with Function 112 (raster format).
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-L90, TM-P60
TM-J2000/J2100
This printer is equipped with a print head configured in column format, which makes it faster to
define data using Function 113 (column format) than with this function.
Use the following settings for best performance.
■ Specify the horizontal size of graphics as 64 dots and horizontal single × vertical single size settings
[( yL + yH × 256) = 64, bx = 1, by = 1] when setting the dot density to [180 dpi × 180 dpi] with Function 49.
■ Specify the horizontal size of graphics as 128 dots and horizontal single × vertical single size settings
[( yL + yH × 256) = 128, bx = 1, by = 1] when setting the dot density to [360 dpi × 360 dpi] with Function 49.
The dot density and maximum print area are the same as Function 69. See the model information
of Function 69.
TM-T90
This printer does not support this function.
TM-L90
This printer does not support this function.
TM-P60
This printer does not support this function.
d1 dY +1 ... :
d2 dY +2 ... dk -2
:: ... dk -1
dY dY x2 ... dk Y = ( yL + yH × 256)

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English