Epson TM-T88III

CONFIDENTIAL
Paper roll Status commands DLE EOT
Ver. 10.01 p. 309
TM-T90
BUSY condition for a parallel interface is selected by memory switch 1-3.
■ Roll paper sensor status ( n = 4)
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-L90
BUSY condition for a parallel interface is selected by memory switch 1-3.
■ Error cause status ( n = 3)
If the cause of the recoverable error (bit 2) is the paper layout error, the printer can recover from
the error by opening/closing the roll paper cover in addition to by the DLE ENQ command only
when memory switch Msw8-2 is OFF. The error recovery operation differs according to the status
of Msw8-2. See the model information of Function 3 of GS ( E for details.
■ Roll paper sensor status (n = 4)
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-T88III
BUSY condition for a parallel interface is selected by DIP switch 2-1.
■ Printer status ( n = 1)
Bits 5 and 6 of the printer status are undefined.
■ Error status ( n = 3)
Bit 2 of the error status is undefined.
■ Roll paper sensor status ( n = 4)
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.