Epson TM-T88III

CONFIDENTIAL
Paper roll Status commands DLE EOT
Ver. 10.01 p. 311
Bit 2 of the error cause status is not supported.
■ Roll paper sensor status ( n = 4)
Bits 2 and 3 of the roll paper sensor status are not supported.
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-U230
BUSY condition for a parallel interface is selected by DIP switch 1-8.
■ Printer status ( n = 1)
Bit 6 of the printer status is undefined.
TM-U210
BUSY condition for a parallel interface is selected by DIP switch 1-8.
■ Printer status ( n = 1)
Bit 6 of the printer status is undefined.
■ Offline status ( n = 2)
Bit 2 of the offline status is undefined.
■ Roll paper sensor status ( n = 4)
The roll paper near-end sensor is an option. If the printer is not equipped with the paper near-end
sensor, bits 2 and 3 of the third byte are always ON, “Paper adequate.”