Epson TM-T88III

CONFIDENTIAL
Paper roll Status commands GS a
Ver. 10.01 p. 323
TM-T90
The default value is set by Msw 1-3.
■ Third byte (paper sensor information)
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-L90
The default value is set by Msw 1-3.
■ Basic second byte (printer information)
If the cause of the recoverable error (bit 2) is the paper layout error, the printer can recover from
the error by opening/closing the roll paper cover or by the DLE ENQ command only when memory
switch Msw8-2 is OFF.
■ Basic third byte (paper sensor information)
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.