Epson TM-T88III

CONFIDENTIAL
Paper roll Status commands GS a
Ver. 10.01 p. 325
■ Basic third byte (paper sensor information)
Bits 0 and 1 of the third byte are not supported.
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-U230
The default value is set by DIP switch 1-8.
■ Second byte (printer information)
Bit 1 of the second byte is undefined.
TM-U220
The default value is set by DIP switch 1-8.
■ Second byte (printer information)
Bit 0, and 1 of the second byte are undefined.
TM-U210
The default value is set by DIP switch 1-8.
■ First byte (printer information)
Bit 5 of the first byte is undefined.
■ Second byte (printer information)
Bit 1 of the first byte is undefined.
■ Third byte (paper sensor information)
The roll paper near-end sensor is an option. If the printer is not equipped with the paper near-end
sensor, bits 0 and 1 of the third byte are always ON, “Paper adequate.”