Epson TM-T88III Programming Guide

CONFIDENTIAL
Paper roll Bar code commands GS k
Ver. 10.01 p. 346
• k of (A) indicates the number of bytes of bar code data . k is an explanation parameter; therefore it
does not need to be transmitted.
• n of (B) specifies the number of bytes of bar code data.
• d specifies the character code data of the bar code data to be printed.
[Notes]
■ When standard mode is selected, this command is enabled only when the print position is at the head of a
line or when no data exists in the print buffer.
■ When page mode is selected, this command develops the bar code data in the print buffer but the printer
does not print the bar code data.
■ The bar code width that exceeds the print area cannot be specified.
■ This command feeds as much paper as is required to print the bar code, regardless of the line spacing
specified by line space setting commands.
(B)
65 UPC-A Fixed 11 ≤ n ≤ 12 0~9 48 ≤ d ≤ 57
66 UPC-E Fixed 11 ≤ n ≤ 12 0~9 48 ≤ d ≤ 57
67 JAN13 (EAN13) Fixed 12 ≤ n ≤ 13 0~9 48 ≤ d ≤ 57
68 JAN8 (EAN8) Fixed 7 ≤ n ≤ 80~9 48 ≤ d ≤ 57
69 CODE39 Can be changed 1 ≤ n ≤ 255 0~9, A~Z
SP, $, %, *, +, -, ., /
48 ≤ d ≤ 57, 65 ≤ d ≤ 90,
d = 32, 36, 37, 42, 43, 45, 46, 47
70 ITF
(Interleaved 2 of 5)
Can be changed
(even number)
2 ≤ n ≤ 255
(even number)
0~9 48 ≤ d ≤ 57
71 CODABAR
(NW7)
Can be changed 1 ≤ n ≤ 255 0~9, A~D, a~d
$, +, -, ., /, :
48 ≤ d ≤ 57, 65 ≤ d ≤ 68, 97 ≤ d ≤ 100
d = 36, 43, 45, 46, 47, 58
72 CODE93 Can be changed 1 ≤ n ≤ 255 00H~7FH 0 ≤ d ≤ 127
73 CODE128 Can be changed 2 ≤ n ≤ 255 00H~7FH 0 ≤ d ≤ 127
m Bar code system
Bar code data (“SP” in the table indicates space.)
Amount
of data
The range of
k Characters Character code ( d )

Epson TM-T88III Specifications

General

Brand	Epson
Model	TM-T88III
Category	Printer
Language	English