CONFIDENTIAL
Paper roll Mechanism control commands GS V
Ver. 10.01 p. 377
TM-U220
This printer may make “dot displacement” after autocutting. It is recommended to feed
approximately 2.116 mm or more for printing the next line to prevent “dot displacement after
cutting.”
Since TM-U220D is not equipped with an autocutter, it can use only Function B. The printer feeds
paper for [manual cutter position + (
n
× approximately 0.176 mm {1/144 inch})].
The cutting shapes of (
m
= 0,48) and (
m
= 1,49) are the same as the cutting shape of (
m
= 65)
and (
m
= 66). The setting is partial cut (one point is left) when the printer is shipped.
The distance from print head to autocutter is about 27 mm {1.06 inches} in the TM-U220A and
TM-U220B. The distance from print head to emergency cutter is about 22.1 mm {0.87 inch} in
TM-U220D.
To Next Page
Loading...
