CONFIDENTIAL
Paper roll Miscellaneous commands ESC ( A
Ver. 10.01 p. 405
•
c
specifies the beeps integrated beeper/ not beeps integrated beeper when specified offline is
occurred.
•1 ≤
t1
≤ 50
specify beeping time (
t1
× 100 ms).
t1
= 255 specify beeping time (infinity).
•
t2
specify time for stop beeping (
t2
× 100 ms).
[Notes]
■ This function repeats integrated beeper control of [(
t1
× 100 ms) beep/ (
t2
✕ 100 ms) stop] when offline
factors have occurred. However, (
t1
= 255) causes continuous beeping.
■ When the printer is offline, the integrated beeper will stops under any of the following conditions:
• The offline factor is cleared.
• The FEED switch is pressed.
• Reset or power off.
■ Setting of this function is enabled until reset or power off.
c
Beeping method
0 Beeps integrated beeper
255 Does not beep the integrated beeper
To Next Page
Loading...
Need help?
General