Epson TM-T88III

CONFIDENTIAL
Paper roll Miscellaneous commands GS I
Ver. 10.01 p. 462
TM-T90
• Printer model ID ( n = 1, 49)
Hex = 2EH / Decimal = 46 [When Japanese model is used or memory switch [Msw 8-7] is OFF.]
Hex = 20H / Decimal = 32 [When memory switch [Msw 8-7] is ON.]
• Type ID ( n = 2, 50)
Bit 1: [Autocutter is installed/not installed] indicates the state of Memory switch 2-2.
Bit 2: The bit [DM-D (Customer display) isn’t supported.
• Version ID ( n = 3,51)
By the firmware version [When Japanese model is used or memory switch [Msw 8-7] is OFF.]
Hex = 46H / Decimal = 70 [When memory switch [Msw 8-7] is ON.]
• Printer model ( n = 67)
Printer model: TM-T90
• Model-dependent printer information ( n = 112) send information of DIP switch as follows.
Send data is 4 bytes data group composed of [header + printer information (2 bytes) + NUL].
<1st byte of DIP switch information>
Bit Off/On Hex Decimal Function
0 Off 00 0 DIP switch 1 OFF
On 01 1 DIP switch 1 ON
1 Off 00 0 DIP switch 2 OFF
On 02 2 DIP switch 2 ON
2 Off 00 0 DIP switch 3 OFF
On 04 4 DIP switch 3 ON
3 Off 00 0 DIP switch 4 OFF
On 08 8 DIP switch 4 ON