Epson TM-T88III

CONFIDENTIAL
Paper roll Miscellaneous commands GS I
Ver. 10.01 p. 466
Bit 2 of the Type ID is different from the standard ESC/POS as shown in the following table:
Bit 2: When the following DIP switches are ON, thermal label paper is selected.
Paper selection for a serial interface is selected by DIP switch 2-6.
Paper selection for a parallel interface is selected by DIP switch 1-7.
TM-P60
• Printer model ID ( n = 1, 49)
Hex = 4AH / Decimal = 74
• Type ID (n = 2, 50)
Bit 0: [Multi-byte code characters not supported] is always transmitted.
Bit 1: [Autocutter installed] is always transmitted.
Bit 2: [DM-D (Customer display) not connected] is always transmitted.
• Type information ( n = 33)
Type information of this printer consists of 2 bytes, the fixed value [Hexadecimal = 40H/Decimal =
64] is transmitted to the second byte.
Bit 0 of the first byte: [Multi-byte code characters not supported] is always transmitted.
Bit Off/On Hex Decimal Function
0 Off 00 0 2 byte code characters are not supported
1 Off 00 0 Autocutter is not installed
2 Off 00 0 Select thermal paper (DIP switch (paper selection) is Off.)
On 04 4 Select thermal label (DIP switch (paper selection) is On.)
3 Off 00 0 Reserved
4 Off 00 0 Fixed
5 Off 00 0 Reserved
6 Off 00 0 Reserved
7 Off 00 0 Fixed