CONFIDENTIAL
Paper roll Two-dimension code commands GS ( k
Ver. 10.01 p. 515
TM-T90
This model supports two-dimensional code (PDF417 )
When printing PDF417 with this printer, note the following:
■ The recognition rate of the symbol is affected by the height of the symbol, module height, module width
ratio, and the performance of the reader.
■ It is recommended that the module height and module width be set so that the height of the symbol is
bigger than 5 mm {0.2 inch}.
■ It is recommended that the module height be set three to five times the width of the module.
■ The module height is specified by Function 068. The width of a module is specified by Function 067. The
number of the rows is specified by Function 066.
■ The size of the symbol is confirmed by the transmission data of Function 082.
TM-L90
This model supports two-dimensional code (PDF417, QR Code, MaxiCode )
When printing PDF417 with this printer, note the following:
■ The recognition rate of the symbol is affected by the height of the symbol, module height, module width
ratio, and the performance of the reader.
■ It is recommended that the module height and the width of a module be set so that the height of the
symbol is bigger than 5 mm {0.2 inch}.
■ It is recommended that the module height be set to three to five times the width of the module.
■ The module height is specified by Function 068. The width of a module is specified by Function 067. The
number of the rows is specified by Function 066.
■ The size of the symbol is confirmed by the transmission data of Function 082.
To Next Page
Loading...
Need help?
General