CONFIDENTIAL
Paper roll Counter printing commands GS C 1
Ver. 10.01 p. 638
■ In a count-down setting, when GS c is executed, the counter value is below minimum value
(
bL
+
bH
× 256), restart counting from the maximum value (
aL
+
aH
× 256).
■ In a count-stop setting, when executing GS c, the counter value is not changed.
■ When this command is executed, the internal counter which counts the repetition number of printing is 0.
■ This command does not change the counter value. The counter value is set by GS C 2.
■ The settings for a range of a counter set by GS C ;, stepping amount of incrementing or decrementing of
a counter value, the repetition number of printing are disabled by processing this command.
■ Settings of this command are effective until GS C ; is executed, ESC @ is executed, the printer is reset, or
the power is turned off.
■ The value of the counter is updated when executing GS c.
To Next Page
Loading...
Need help?
General