Esser 8000C - Page 183

Fire Alarm Computer 8000C / M
Page 183
Trouble
code no.
Possible cause 1st measure 2nd measure
069
There are more detectors
on the loop than
programmed in the
customer data.
If this change is not
desired, connect service
PC and run a configuration
check. Re-program
customer data.
---
070
The allocation of the
detector was changed at
the installation place.
If this change is not
desired, connect service
PC and run a configuration
check. Re-program
customer data.
---
080
This detector change may
only be performed with the
service PC because this
detector required custome
r
data that cannot be
generated in the panel
itself.
If this change is not
desired, connect service
PC and run a configuration
check. Re-program
customer data.
---
081
An OTI-detector has been
installed at detector
location. The sensor type
has changed in
comparison with the
customer data
Check whether detector
type change is desired; if i
t
is, activate analog loop.
Otherwise install detector
you require and re-start
Detector change
082
An OT-detector has been
installed at detector
location. The sensor type
has changed in
comparison with the
customer data
Check whether detector
type change is desired; if i
t
is, activate analog loop.
Otherwise install detector
you require and re-start
Detector change
083
An I-detector has been
installed at detector
location. The sensor type
has changed in
comparison with the
customer data
Check whether detector
type change is desired; if i
t
is, activate analog loop.
Otherwise install detector
you require and re-start
Detector change
084
A TM-detector has been
installed at detector
location. The detector type
has changed in
comparison with the
customer data
Check whether detector
type change is desired; if i
t
is, activate analog loop.
Otherwise install detector
you require and re-start
Detector change
085
A TME-detector has been
installed at detector
location. The detector type
has changed in
comparison with the
customer data
Check whether detector
type change is desired; if i
t
is, activate analog loop.
Otherwise install detector
you require and re-start
Detector change
Meaning of the three-digit trouble cod
e