evertz 3025EMC - Page 117

3025EMC Master Control Switching & Channel Branding
Revision 3.0.3 Page 103
Audio Lag
Transition
Active when this audio
mode is selected
N/A N/A
Audio Lead
Transition
Active when this audio
mode is selected
N/A N/A
Fade to Black
Active when in fade to
black/silence
N/A N/A
Bypass QMC
Active when in bypass
N/A
N/A
Preroll Source
Active with the source
defined by parameter
1 is selected on the
preset bus and a
transition is active, or
on the program bus
Source is ZERO
based.
Source number. 0 for
source 1, 1 for source
2, etc.
Bus number. 0 for
PST bus during
transition, or 1 for the
program bus.
Mix Lead Active
Not supported
Mix Lag Active
Not supported
Preset Source
Active when the
source defined by
parameter 1 is
selected on the preset
bus
Source number ZERO
based.
N/A
Program Source
Active when the
source defined by
parameter 1 is
selected on the
program bus
Source number ZERO
based.
N/A
Program Source
Binary Coded
Active for the program
source currently in
use. Multiple GPOs
can be combined in
binary mode. e.g. 4 x
GPO for 16 sources.
Parameter 1 specifies
the bit number
Bit Number.
2 sources = 0
4 sources = 0&1
8 sources = 0&1&2
16 sources =
0&1&2&3
N/A
Logo Selection
Not Supported on
EMC
DVE Level
Active when the DVE
Level Key on control
panel is selected
0: Primary DVE
1: Secondary DVE
N/A
DVE On-Air
Active when the DVE
is on the Program bus
0: Primary DVE
1: Secondary DVE
N/A
Current DVE Move
Active when the
currently selected DVE
move is the same as
parameter 1
DVE Move. 1 for
move 1, 2 for move 2,
etc.
N/A
DVE Background
Source
Not currently
supported.