evertz 3025EMC - Page 118

3025EMC Master Control Switching & Channel Branding
Page 104 Revision 3.0.3
DVE Move Selected
Active when the
currently selected DVE
move is the same as
parameter 1
DVE Move. 1 for
move 1, 2 for move 2,
etc.
N/A
Manual GPO
Used with
corresponding “GPI/O
Toggle” & “GPO
Activate” buttons on
QMC-DCP/EMC-DCP
panels.
Also used for GPO
trigger for preroll takes.
N/A N/A
GPO System Event
Used with GPO
Trigger Macro and for
debugging ATC
switching
Macro Trigger
4 = enable
ATC Debug
4 = enable for GPO #3
ONLY.
Macro Trigger
Number of frames for
GPO to stay active
low when triggered.
ATC Debug
N/A
Start Macro
Active when the Macro
is the same as
parameter 1
Macro. 1 for macro 1,
2 for macro 2, etc.
N/A
Dolby decoder loss
of signal
Active when the PGM
Dolby E Decoder
doesn’t detect Dolby
E.
Set to 0 for Decoder 1.
Set to 1 for Decoder 2.
N/A
Dolby Encoder
Active
GPO ON when
specified encoder is
either on-air or primed
to transition off-air.
GPO OFF at all other
times.
Set 0 for Encoder 1.
Set 1 for Encoder 2.
N/A
Genlock signal is
present
Not currently
supported.
Video signal is
present
Not currently
supported.
Automation On
Active when
automation button on
panel is On.
N/A
N/A
EAS Active
Active when an EAS
message is being
displayed by the EMC
N/A
N/A
MG Script
Use the GPO script
that is configured for
the GPO. The script is
stored on the EMC’s
compact flash.
N/A N/A