evertz 3025EMC - Page 203

3025EMC Master Control Switching & Channel Branding
Revision 3.0.3 Page 189
Voiceover3Gain Up
(EMC)
Selected Pair or Group
Adjust VO3 input gain
up.
Note: If multiple
channels are set then
tally will not show on the
button.
Voiceover3Gain Down
(EMC)
Selected Pair or Group
Adjust VO3 input gain
down.
Note: If multiple
channels are set then
tally will not show on the
button.
Voiceover4Gain Up
(EMC)
Selected Pair or Group
Adjust VO4 input gain
up.
Note: If multiple
channels are set then
tally will not show on the
button.
Voiceover4Gain Down
(EMC)
Selected Pair or Group
Adjust VO4 input gain
down.
Note: If multiple
channels are set then
tally will not show on the
button.
Voiceover5Gain Up
(EMC)
Selected Pair or Group
Adjust VO5 input gain
up.
Note: If multiple
channels are set then
tally will not show on the
button.
Voiceover5Gain Down
(EMC)
Selected Pair or Group
Adjust VO5 input gain
down.
Note: If multiple
channels are set then
tally will not show on the
button.
Stereo Mode
Not Supported
Program Input Phase
Not Supported
Preset Input Phase
Not Supported
EMG Input Phase
Not Supported
Voiceover1Input
Phase
Not Supported
Voiceover2Input
Phase
Not Supported
Voiceover3Input
Phase (EMC)
Not Supported
Voiceover4Input
Phase (EMC)
Not Supported
Voiceover5Input
Phase (EMC)
Not Supported
Aux
Monitor Destinations
Select which Aux Audio
Channel Pair will be
controlled.
Aux Monitor Ch 1&2…
Aux Monitor Ch 15&16
N/A
Aux Pre-Shuffle Mono
Sources
Route pre-shuffler Mono
Sources to the selected
Aux Monitor Destination
Define the bus and
mono channel.
N/A
Aux Pre-Mix Mono
Sources
Route pre-mixer Mono
Sources to the selected
Aux Monitor Destination
Define the bus and
mono channel.
N/A
Aux Post-Mix Mono
Sources
Route post-mixer Mono
Sources to the selected
Aux Monitor Destination
Define the bus and
mono channel.
N/A