evertz 3025EMC - Page 207

3025EMC Master Control Switching & Channel Branding
Revision 3.0.3 Page 193
DVE Crop In
Not Currently Supported
DVE Crop Out
Not Currently Supported
DVE Border Width Up
Not Supported
DVE Border
Width Down
Not Supported
DVE Border
Softness Up
Not Supported
DVE Border
Softness Down
Not Supported
DVE Border
Width In
Not Supported
DVE Border
Width Out
Not Supported
DVE Background
Source
Source Number
Change the crosspoint
assignment for the
current DVE Background
source.
Note: The current DVE
Background input for
the DVE might not
always be DVE1 IN.
Dual DVE Priority
DVE A Highest/DVE-B
Highest
Change the DVE Priority
to DVE A or DVE B.
Note: This setting only
takes effect if BOTH
DVEs are active.
Machine Control Stop
N/A
Sony VTR Control
N/A
Machine Control Play
N/A
Sony VTR Control
N/A
Machine Control Rew
N/A
Sony VTR Control
N/A
Machine Control FFWD
N/A
Sony VTR Control
N/A
Machine Control
Record
N/A
Sony VTR Control
N/A
Machine Control Pause
N/A
Sony VTR Control
N/A
Machine Control
Shuttle FWD
N/A
Sony VTR Control
N/A
Machine Control
Shuttle BWD
N/A
Sony VTR Control
N/A
Machine Control Cue
N/A
Sony VTR Control
N/A
Machine Control Time
In
N/A
Sony VTR Control
N/A
Machine Control Time
Out
N/A
Sony VTR Control
N/A
Machine Control Time
Display
N/A
Sony VTR Control
N/A
Machine Control Time
Preroll
N/A
Sony VTR Control
N/A
Machine Control Port
Serial 1,2,3 or 4
Sony VTR Control
Note: If no Port is
selected commands will
be sent to the last port
configured to Sony 9-
Pin Protocol by default.
Macro Selection
Macro # 1 to 255
Select a Macro.
N/A