evertz 3025EMC - Page 206

3025EMC Master Control Switching & Channel Branding
Page 192 Revision 3.0.3
DVE Move Secondary
Move Number (1 to 63)
Select a Secondary
DVE move by number.
Note: When a move is
selected any crosspoint
changes configured in
the move will take place
immediately when the
move is selected.
DVE Left
N/A
Adjust the X position of
the DVE end frame
position to the left.
Note: This can only be
done when a move is
previewed (NOT on-air).
Note: This only applies
to Primary DVE Moves.
DVE Right
N/A
Adjust the X position of
the DVE end frame
position to the right.
Note: This can only be
done when a move is
previewed (NOT on-air).
Note: This only applies
to Primary DVE Moves.
DVE Up
N/A
Adjust the Y position of
the DVE end frame
position up.
Note: This can only be
done when a move is
previewed (NOT on-air).
Note: This only applies
to Primary DVE Moves.
DVE Down
N/A
Adjust the X position of
the DVE end frame
position down.
Note: This can only be
done when a move is
previewed (NOT on-air).
Note:
This only applies
to Primary DVE Moves.
DVE Size Up
N/A
Adjust the size of the
DVE end frame up by %
with respect to the full
raster size.
Note: This can only be
done when a move is
previewed (NOT on-air).
Note: This only applies
to Primary DVE Moves.
DVE Size Down
N/A
Adjust the size of the
DVE end frame down by
% with respect to the full
raster size.
Note: This can only be
done when a move is
previewed (NOT on-air).
Note: This only applies
to Primary DVE Moves.
DVE Crop Up
Not Currently Supported
DVE Crop Down
Not Currently Supported
Preview DVE
Normal/Primary DVE or
Secondary DVE
Preview (PST Bus) the
selected DVE Move.
N/A
Take DVE
Normal/Primary DVE or
Secondary DVE
Take (On-Air) the
selected DVE Move.
N/A