evertz 3025EMC - Page 205

3025EMC Master Control Switching & Channel Branding
Revision 3.0.3 Page 191
Wipe Width Up
N/A
Adjust the wipe width up.
N/A
Wipe Width Down
N/A
Adjust the wipe width
down.
N/A
Wipe Softness Up
N/A
Adjust the wipe softness
up.
N/A
Wipe Softness Down
N/A
Adjust the wipe softness
down.
N/A
Wipe Direction
(scrolling)
Adjust the wipe direction
to either normal, inverted
or flip-flop.
N/A
Wipe Angle Up
N/A
Adjust the wipe angle up.
N/A
Wipe Angle Down
N/A
Adjust the wipe angle
down.
N/A
Wipe Special
Mid Wipe Point, Wipe
Mode, Run Wipe Mode
Configure the wipe
special settings.
N/A
DVE Level
Normal/Primary DVE or
Secondary DVE
Set the level of the DVE.
Transitional on or off air.
N/A
DVE On-Air
Normal/Primary DVE or
Secondary DVE
Set the on-air state of the
DVE.
N/A
DVE Move Normal
Primary
Move Number (1 to 63)
Select a Primary DVE
move by number. Where
this Primary move is in
the DVE Table.
Note: When a move is
selected any crosspoint
changes configured in
the move will take place
immediately when the
move is selected.