evertz 7700 - 4.10. Temperature Configuration Items

7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
RCP OPERATION Revision 1.4 Page 4-31
4.12. TEMPERATURE CONFIGURATION ITEMS
The 7725DSK-LG has the ability to insert a logo that displays the current local temperature. The
Temperature setup menu is used to configure parameters relating to these types of logos. The
following section provides detailed information about each of the sub-menu items:
Temperature Source
Configures the source of the temperature
Temperature Format
Configures the format of the temperature
Set Temperature
Sets the static temperature
Temp Read Loss
Configures the behaviour on the loss of the temperature source
4.12.1. Setting the Temperature Source
Temperature
Temp Source
Source: Probe
Source: Manual
Source: METAR
This menu item is used to select the source of the temperature that will be
displayed in temperature type logos.
Select Probe to take the temperature from the optional temperature probe.
See section 2.9 for more information on using the temperature probe.
Select Manual to manually set the temperature via the Set Temperature
menu item.
Select METAR to take the temperature from METAR data acquired via the
Internet. See section 5.1.3 for more information on configuring the
7725DSK-LG to acquire METAR data.
4.12.2. Setting the Temperature Format
Temperature
Temp Format
Format: Fahrenhe
Format: Celsius
This menu item is used to set the format of the temperature as set by the
Set Temperature menu item.
Select Fahrenhe if the temperature entered is in degrees Fahrenheit.
Select Celsius if the temperature entered is in degrees Celsius.
Note: This menu item is only used when the Temp Source menu item is
set to Manual. When you create a temperature logo, you select the format
as well. If for example you have created a temperature logo that is
formatted for Celsius and you manually set the temperature in degrees
Fahrenheit, the 7725DSK-LG will automatically convert the value to
degrees Celsius so that the correct value is displayed in the logo.