evertz 7700 - Setting the Logo Vertical Position; Setting the Logo Transparency; Setting the Logo Fade in Duration; Setting the Logo Display Time

7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
RCP OPERATION Revision 1.4 Page 4-37
4.14.2. Setting the Logo Vertical Position
MEDIA
V
V:0
0 to max lines
This menu item is used to set the vertical position for the current logo. The
position is referenced to the top edge of the logo. The range of values
depends on video standard in use.
Use the Ï or Ð buttons to adjust the position. The logo will move on the
screen as you adjust its position.
4.14.3. Setting the Logo Transparency
MEDIA
Gain
Gain: 100%
This menu item is used to adjust the opacity (the inverse of transparency)
of the logo as a percentage of the original opacity when the logo was
created. When the Logo Gain is set at its default value of 100 the logo will
be displayed at its original opacity.
For example, if the logo is created at 10% opaque, adjusting the Gain value
to 200 will render the logo as 20% opaque. If the logo is created at 50%
opaque, adjusting the Gain value to 200 will render the logo as 100%
opaque. Gain values resulting in opacity levels above 100% are ignored.
Use the Ï or Ð buttons to adjust the Gain and then press the SELECT
button to set the change.
4.14.4. Setting the Logo Fade In Duration
MEDIA
Fade In
Fade In: 30f
This menu item is used to set the fade in rate for the current logo. The
range of values is 1 to 600 frames. The Fade In menu item only applies to
static and crawl logos.
Use the Ï or Ð buttons to adjust the Fade In time and then press the
SELECT button to set the Fade In time.
4.14.5. Setting the Logo Display Time
MEDIA
Hold
Hold: manual
Hold: 1 to 600f
This menu item is used to set how long the current logo will be displayed.
The range of values is 1 to 600 frames. The logo will automatically fade out
after the Hold Time has been completed. Setting the value to manual will
cause the logo to be displayed until it is manually faded out. The Hold Time
menu item only applies to static and crawl logos.
Use the Ï or Ð buttons to adjust the Hold Time and then press the
SELECT button to set the hold.