evertz 7700 - Configuring the Logo Function

7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
VLPRO OPERATION Revision 1.4 Page 3-19
CUE: Select CUE to load the logo selected by the CLogo menu item into memory.
The logo will not be displayed by this action.
IN: Select IN to load the logo selected by the CLogo menu item into memory and
fade it in.
OUT: Select OUT to fade out the logo selected by the CLogo menu item.
TOGGLE: Select TOGGLE when the GPI is closed.
DUCK IN: Select DUCK IN to begin a ‘Duck Audio Insert’.
DUCK OUT: Select DUCK OUT to end a ‘Duck Audio Insert’.
DUCK: Select DUCK to toggle the state of the 'Duck Audio Insert'. If a 'Duck Audio
Insert' is in effect it will be stopped or if a 'Duck Audio Insert' is not in effect it will
be started. This function is useful if you want to use a momentary contact
closure as opposed to a maintained contact closure to trigger a voice-over, but
the disadvantage is that the current state of the voice-over is not guaranteed.
ALL OUT: Select ALL OUT to fade out all logos.
TIMER1 or TIMER2: Select TIMER1 or TIMER2 to initiate a count up or count down function
for a time logo.
3.8.2.4. Configuring the Logo Function
The Logo option is used to select a logo to be acted on if the “Closed Action” item is set to CUE, IN or
OUT.
NONE: Select NONE to disable any logo actions.