7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
Page 4-16 Revision 1.4 RCP OPERATION
4.6.5.4. Displaying the Ethernet Hardware Address
GENERAL
Network Info
0:2:C5:00:4F:7E
This menu item displays the Ethernet hardware address of the unit (which
cannot be changed).
4.6.6. Displaying SNMP Trap Destination
GENERAL
SNMP Trap Dest
+ 0 .0. 0. 0
This menu item allows the user to configure an IP address for the trap
destinations to be used in an SNMP agent.
4.6.7. Displaying AFD Logo Trigger
GENERAL
AFD Trigger
AFD code: off
AFD code:xxxx
This parameter allows the user to detect a particular AFD code in the HD
VANC. The codes are based on SMTPE 2016.
This feature is only available on HD units.
GENERAL
AFD Trigger
L:
This allows the user to specify the line from which AFD is decoded.
This feature is only available on HD units.
GENERAL
AFD Trigger
Mode: DSK
Mode: Logo
This parameter allows the user to select what action will be taken when a
trigger is received.
When set to DSK mode the downstream keyer will be turned on.
When set to Logo mode the logo that is specified will be turned on when a
trigger is received.
This feature is only available on HD units.
4.6.8. Setting the Serial Protocol for COM Ports D and E
The three serial ports (COM D and COM E) the breakout cable for the 7725DSK-LG are used for
various functions. The SERIAL CONTROL (COM C) port and COM D ports are programmable and can
be used for a variety of functions. The menu items for COM B, COM C, and COM D are the same. For
simplicity, only one of these menu items will be shown in the manual.
"
Please note that COM A and COM B ports are read only and are not configurable.
To Next Page
Loading...
