evertz 7700 - Displaying the Local Time; Displaying the UTC Time; Setting the Real Time Clock

7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
Page 4-12 Revision 1.4 RCP OPERATION
4.6.4.1. Displaying the Local Time
GENERAL
Time Setup
Local 12:34:50
This menu item is used to display the clock time as local time. (UTC time
adjusted for the time zone offset and DST adjustment). The time displays
are always shown in the 24 hour time format.
4.6.4.2. Displaying the UTC Time
GENERAL
Time Setup
UTC 12:34:50
This menu item is used to display the UTC time clock. The time displays
are always shown in the 24 hour time format.
4.6.4.3. Setting the Real Time Clock
GENERAL
Time Setup
RTC 12:34:50
This menu item is used to display and set the hardware real time clock in
the 7725DSK-LG. The time displays are always shown in the 24 hour time
format.
When you press the SELECT button, the display shows the current real
time clock time which will look similar to the following:
12:34:50
To set the real time clock press the SELECT button and the hours digits
will be flashing to indicate that they are in entry mode. Use the Ï or Ð
buttons to change the hours to the desired value. Then press the SELECT
button and the minute’s digits will begin flashing to indicate that they are in
entry mode. Set the minutes and seconds in the same way. When you
have entered the correct time press the SELECT button to update the
hardware real time clock. The second’s digits will stop flashing and the
time will begin incrementing indicating that the Real Time Clock has been
set. When you set the hardware real time clock the UTC clock time will
automatically be adjusted.
"
When there is a valid LTC input to the 7725DSK-LG, the LTC time will overwrite the
Real Time clock that has been entered.