evertz 7700 - Function Button Group

7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
Page 6-4 Revision 1.4 DESKTOP CONTROL PANEL
When the Transition Swap Mode is set to Swap the input video and audio of the Preview
Bus and the Program Bus will be swapped at the end of the transition. Logos and other
media being keyed on the respective buses will also be swapped with the inputs.
When the Transition Swap Mode is set to No Swap the input video and audio of the Preview
Bus will be transferred to the Program Bus transition. Logos and other media being keyed
on the Preview Bus will also be transferred to the Program Bus. The Preview Bus will
remain unchanged.
RATE: This button provides immediate access to the Transition Rate menu item of the
TRANSITION menu. See section 4.10.2 for more information on the Transition Type menu
item. After pressing the RATE button you may use the shaft encoders to cycle through the
Transition rate range measured in video frames. Press SELECT to accept the changes or
SETUP to escape without making any changes.
6.1.3. Function Button Group
KEY SELECT: This button provides immediate access to the Key Type menu item of the DSK
menu. See section 4.9.1 for more information on the Key Type menu item. After pressing
the KEY SELECT button you may use the shaft encoders to choose Input or Self Key DSK
Key Type. Press SELECT to accept the changes or SETUP to escape without making any
changes.
THRESHOLD: This button provides immediate access to the Key Threshold menu item of the
DSK menu. This menu item is used to set the luminance value of the Fill signal that will be
used to key the image when the Key Type is set to Self Key. See section 4.9.4 for more
information on the Key Threshold menu item. After pressing the THRESHOLD button you
may use the shaft encoders to cycle through the Key Threshold values. Press SELECT to
accept the changes or SETUP to escape without making any changes.
GAIN: This button provides immediate access to the Key Gain menu item of the DSK menu. This
menu item is used to adjust the transparency of the keyed image from the transparency of
the Key signal when the Key Type is set to Input. See section 4.9.2 for more information
on the Key Gain menu item. After pressing the GAIN button you may use the shaft
encoders to cycle through the Key Gain values. Press SELECT to accept the changes or
SETUP
to escape without making any changes.
PRESET SAVE: This button provides immediate access to the Store Preset menu item of the
PRESETS menu. This menu item is used to save the settings of the unit to one of ten user
preset areas so they can be recalled later. See section 4.11.4 for more information on the
Store Preset menu item. After pressing the PRESET SAVE button you may use the shaft
encoders to select the preset number to save the settings to. When you press the SELECT
button, the settings will be saved overwriting any preset that was previously stored at that
location. Press SETUP to escape without saving the preset.