7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
DESKTOP CONTROL PANEL Revision 1.4 Page 6-3
FILL: This button selects the video from the PGM IN B input, as well as selecting the audio
source. If the button LED is flashing then the PGM IN B video and associated audio is
being output on the Preview Bus. If the button LED is ON solid then the FILL/B video and
associated audio is being output on the Program Bus. Selecting FILL deselects the BKG,
BLACK and DSK buttons for the applicable bus. You can use the PGM and PRV buttons to
toggle control/status between the two buses to verify the input status for each bus.
BLACK: This button selects the video from the built in Black generator. If the button LED is flashing
then the Black video is being output on the Preview Bus. If the button LED is ON solid then
the Black video is being output on the Program Bus. Selecting BLACK deselects the BKG,
FILL and DSK buttons for the applicable bus. You can use the PGM and PRV buttons to
toggle control/status between the two buses to verify the input status for each bus.
LOGO: This button controls the complete media key layer for the selected output bus. The media
key layer includes the logo layer for the video and the voiceover layer for the audio. Logos
cannot be displayed and voiceovers cannot be performed when the media key layer is off. If
the button LED is not illuminated, then the media key layer is not active. If the button LED is
flashing then the media key layer is enabled on the Preview Bus. If the button LED is ON
solid then the media key layer is enabled on the Program Bus. You can use the PGM and
PRV buttons to toggle control/status between the two buses to verify the downstream keyer
layer status for each bus.
To control the media key layer, first select the bus you want the media key layer to appear
on using the PGM and PRV buttons. To enable the media key layer on the selected output
bus, press the LOGO button. The button LED will be illuminated (On Solid for Program Bus,
flashing for Preview Bus). To disable the media key layer from the selected output video
bus, press the LOGO button. The button LED will be OFF.
6.1.2. Transition Button Group
EFFECT SELECT: This button provides immediate access to the Transition Type menu item of the
TRANSITION menu. See section 4.10.1 for more information on the Transition Type menu
item. After pressing the EFFECT SELECT button you may use the shaft encoders to cycle
through the Transition types available. Press SELECT to accept the changes or SETUP to
escape without making any changes.
TAKE: This button starts a transition of what is displayed on the Preview Bus to the Program Bus.
The transition Type, Rate and Swap Mode are set using the EFFECT SELECT, RATE and
SWAP MODE buttons or using the menu items in the Transition menu item (see section
4.10). Transitions can also be triggered using GPI, or automation control (see section
4.11.5). The button LED indicates that a transition from the Preview Bus to the Program
Bus is in progress when it is illuminated, regardless of how the transition was triggered.
SWAP AFTER: This button provides immediate access to the Transition Swap menu item of the
TRANSITION menu. See section 4.10.3 for more information on the Transition Swap menu
item. After pressing the SWAP AFTER button you may use the shaft encoders to choose
Swap or No Swap mode. Press SELECT to accept the changes or SETUP to escape
without making any changes.
To Next Page
Loading...
