7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
RCP OPERATION Revision 1.4 Page 4-5
COMM This LED is used to signal two types of communication to the 7725DSK-LG. Flashing ON
approximately every 1.5 seconds indicates that the control panel is communicating with the
main microprocessor in the unit. When the 7725DSK-LG is under automation control, or
logos or other media files are being transferred to or from the unit using Overture™
software, the LED will be on when the unit is receiving data from the control source.
The control panel has lost communication with the main unit if this LED is OFF continuously.
In that case check the cabling if you are using a remote control panel. Otherwise the unit
may require a reboot if the control buttons on the control panel are not responding.
4.1.6. Electronics Unit Status Indicators
PSU STATUS 1, 2 These green LEDs indicate that the corresponding power to the 7725DSK-LG is
functioning normally. PSU STATUS 2 LED will be OFF all the time and is not applicable.
These LEDs are the only ones present on the electronic units of the remote control versions.
4.1.7. Front Panel Display Functions
The 16 character alphanumeric display is used to show the name of the logo that will be faded in or out
by pressing the LOGO IN/OUT button. The display is also used to show the Setup menu items to
configure the downstream keyer.
4.2. OVERVIEW OF FRONT REMOTE CONTROL PANEL OPERATION
4.2.1. Displaying Logos
To control whether a logo is keyed or not, you must first enable the media key layer by pressing the
LOGO button for the bus you want the logo to appear on. The LOGO LED for the respective bus must
be illuminated for logos to display on that bus. Scroll to the logo required using the Ï & Ð buttons. If
the logo is currently being keyed its name will flash in the front panel display. To key the logo into the
output video buses with the media layer enabled, press the LOGO IN/OUT button. The logo will fade in
according to its programmed fade in time and the logo name display will begin flashing. If the logo is
not currently loaded into memory, a progress indicator will appear to the right of the logo name while it
is loading into memory. To remove a keyed logo from the output video buses, press the LOGO IN/OUT
button when the logo name is flashing. The logo will fade out according to its programmed fade out
time and the logo name display will stop flashing.
4.3. AN OVERVIEW OF THE SETUP MENU SYSTEM
The SETUP menu system uses the 16 digit alphanumeric display and provides a quick, intuitive method
of configuring the 7725DSK-LG. These items are often only required to be set up at the time of
installation, and do not pertain to the day-to-day operation of the unit. Figure 4-3 provides an overview
of the Setup menu system.
To Next Page
Loading...
