7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
Page 6-6 Revision 1.4 DESKTOP CONTROL PANEL
6.1.6. Control Panel Status Indicators
The illuminated buttons show operational status of the 7725DSK-LG at a glance. When they are on
they indicate that the function associated with the button is active. The solid LED Output Bus buttons
indicate the status for the Program output bus, and when the buttons are flashing the status of the
preview output bus is indicated.
DSK: This LED indicates that the downstream keyer or media key layer is enabled on the Program
Bus when it is ON. When it is OFF it indicates that the keyer layers are both disabled on the
Program Bus.
COMM: This LED is used to signal two types of communication to the 7725DSK-LG. The LED
flashing ON approximately every 1.5 seconds indicates that the control panel is
communicating with the main microprocessor in the unit. When the 7725DSK-LG is under
automation control, or logos or other media files are being transferred to or from the unit
using the Overture™ software, the LED will be ON when the unit is receiving data from the
control source.
If the LED is continuously OFF then the control panel has lost communications with the main
unit. If this occurs and you are using a remote control panel, check the cabling to make sure
it is correct. Otherwise the unit may require a reboot if the control buttons on the control
panel are not responding.
6.2. OVERVIEW OF DESKTOP CONTROL PANEL OPERATION
6.2.1. Displaying Logos
To control whether a logo is keyed or not, you must first enable the media key layer by pressing the
LOGO button for the bus you want the logo to appear on. The LOGO LED for the respective bus must
be illuminated for logos to display on that bus (see section 6.1.1). Scroll to the logo required using the
SHAFT ENCODERS. If the logo is currently being keyed its name will flash in the front panel display.
To key the logo into the output video bus with the media layer enabled, press the SELECT button. The
logo name display will be flashing. To remove a keyed logo from the selected output video bus, press
the SELECT button. The logo name display will stop flashing.
6.3. AN OVERVIEW OF THE SETUP MENU SYSTEM
The SETUP menu system uses the 16 digit alphanumeric display and provides a quick, intuitive method
of configuring the 7725DSK-LG. These items are often only required to be set up at installation time,
and do not pertain to the day-to-day operation of the unit.
6.3.1. Navigating the Setup Menu
To enter the Setup menu, press the SETUP button. This will bring you to the main Setup menu where
you can use the SHAFT ENCODERS to move up and down the list of available sub-menus. Top level
menu items are shown in UPPERCASE. Once you have chosen the desired sub-menu, press the
SELECT button to select the next menu level.
To Next Page
Loading...
