7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
HTML Revision 1.4 Page 5-3
AUDIOCLIP: This column configures which channel(s) the audioclip audio is to be inserted onto.
Using this item you can also specify the desired mix levels for audio clips. The audioclip layer is on
top of the Black/Bkg/Fill/Audio Keyer layers, therefore the gain settings boost the clip playout and the
duck affects the Black/Bkg/Fill/Audio Keyer layer. The above setting provides for the audio clips (when
playing) to output on all audio channels, the audio is mixed with the left and right channels of the pre-
recorded audioclip. The left and right channels are then mixed with all the output audio channels. You
must configure the audioclip layer in order to hear audio clips on the desired output channels. The logo
layer must be enabled as indicated by the LED on the front panel in order for audio clips to be mixed.
If the logo layer is off, audio clips will play out in memory, but they will not be mixed with the output
audio. The audioclip layer is only active when an audioclip is playing out. EAS over TCP messages
are played according to the audio clip settings, since the audio is transferred to the keyer as a wav file
and played as a normal audio clip.
SOURCE: Specifies the input source for the output audio channel. The following is a description of
each of the choices.
AEMB1L - group 1 channel 1 of embedded audio on the input video
AEMB1R - group 1 channel 2 of embedded audio on the input video
AEMB2L - group 1 channel 3 of embedded audio on the input video
AEMB2R - group 1 channel 4 of embedded audio on the input video
AEMB3L - group 2 channel 1 of embedded audio on the input video
AEMB3R - group 2 channel 2 of embedded audio on the input video
AEMB4L - group 2 channel 3 of embedded audio on the input video
AEMB4R - group 2 channel 4 of embedded audio on the input video
AEMB1M - mono mix of group 1 channels 1 + 2 of embedded audio on the input video
AEMB2M - mono mix of group 1 channels 3 + 4 of embedded audio on the input video
AEMB3M - mono mix of group 2 channels 1 + 2 of embedded audio on the input video
AEMB4M - mono mix of group 2 channels 3 + 4 of embedded audio on the input video
Silence - the output audio channel will contain silence
GAIN: Sets the output gain for the audio channel in question. To pass the audio through at the
received level, set the gain to 0. To boost the audio level, set the gain to a positive
value. To reduce the audio level set the gain to a negative value.
DUCK: Sets the gain for the program audio when an audio mix is in effect. To pass the
background audio through at the received level, set the duck to 0. To boost the
background audio level set the duck to a positive value. To reduce the background
audio level set the duck to a negative value.
NON-PCM: Selects whether the embedded audio is PCM. If the audio is PCM, set Non-PCM to No.
If the audio is not PCM, such as Dolby-E, set Non-PCM to Yes.
Once the unit is set up as per the above specification, select the Submit button to send
the configuration to the unit.
The Update button captures the changes from the unit that may be applied by GPIs or
Automation control and displays the results in the HTML Setup page.
The Revert button, removes any changes that were applied but not submitted.
To Next Page
Loading...
