7700 Multiframe Manual
7725DSK-LG / 7725DSK-LG-HD HD/SD Logo Inserter & Media Keyer
Page 3-30 Revision 1.4 VLPRO OPERATION
3.13.6. Static Logo Configuration Settings
Click on a logo in the media list and the media control menu will appear at the bottom of the view.
Figure 3-15: Static Logo Configuration Settings
3.13.6.1. Setting the Logo Horizontal Position
This option is used to set the horizontal position for the current logo. The position is referenced to the
left edge of the logo. The range of values depends on video standard in use.
3.13.6.2. Setting the Logo Vertical Position
This option is used to set the vertical position for the current logo. The position is referenced to the top
edge of the logo. The range of values depends on video standard in use.
3.13.6.3. Setting the Logo Transparency (Gain)
This option is used to adjust the opacity (the inverse of transparency) of the logo as a percentage of
the original opacity when the logo was created. When the Gain value is set at its default value of 100
the logo will be displayed at its original opacity.
For example, if the logo is created at 10% opaque, adjusting the Gain value to 200 will render the logo
as 20% opaque. If the logo is created at 50% opaque, adjusting the Gain value to 200 will render the
logo as 100% opaque. Gain values resulting in opacity levels above 100% are ignored.
To Next Page
Loading...
