990DSL
Users Guide
4-62
SASS Tests
The SASS (Single Access Service System) tests enable the tester to dial a
C.O.-based Fluke Networks SASS unit for similar VF tests over a working
POTS line.
To run tests in this group, follow the above procedure for “Smart-Pro Tests”.
When prompted, enter the desired test code from Table 4-17.
Table 4-17. SASS Test Key Commands
To run this test: Press key(s):
Milliwatt 86
Quiet Termination 85
3-Tone Sweep 83
10-Tone Sweep 80
Programmable Sweep 87
Callback 7
Keypad 5
To Next Page
Loading...
