Fluke 990DSL - Setting the Date and Time

Setting Up and Operating the CopperPro
Configuring the Tester
3
3-11
Setting the Date and Time
To set the date and time, follow these steps:
1. Press >, then O to display the
USER OPTIONS menu (Figure 3-4).
2. Select
Date/Time. Press L.
The
Date/Time menu is displayed.
3. Press H to move the cursor down to the
Time Display Mode field. Press
A(
Edit). Then, press G to select one of the following formats for
displaying the time:
• 12-hour (default)
• 24-hour
Press L to save your selection.
4. Press H to move the cursor down to the
Date Display Mode field. Press
A(
Edit). Then, press G to select one of the following formats for the date:
• MM/DD/YYYY
• DD.MM.YYYY
Press L to save your selection.
5. Press F to move the cursor up to the
Current Time field and set the time.
To do this, complete the following:
a) Press A(
Edit). In the Hour field, type the hour. Then press L to
save the value.
b) Press G to move the cursor to the Minutes field. Press A(
Edit). Type
the minutes, then press L to save the value.
c) If you selected
12-hour as the time format, press G to move the
cursor to the Time of Day field. Press A(
Edit). Press H to select AM
or
PM, then press L to save the selection.