Fluke 990DSL - Adjusting the Volume of the Speaker; Displaying System Information

990DSL
Users Guide
3-22
Adjusting the Volume of the Speaker
The CopperPro has a speaker that emits a distinctive sound when a key is
pressed or when certain testing operations are being performed.
To increase or decrease the volume of the sound, do the following:
1. Press >. Then, press F to increase the volume or H to decrease the
volume.
When you press the arrow key, the speaker emits a tone at the newly
adjusted volume, giving you a sample of the level of sound.
2. When the volume is acceptable to you, press > again.
The new setting is saved in memory and remains in effect even after you
turn off the tester.
Displaying System Information
To find out what version of software you have or what options are installed on
the tester, complete the following:
1. Press > then
O to display the USER OPTIONS menu (Figure 3-4).
2. Select
System Version. Press L.
The
System Version screen displays the following information about the
tester:
• Software version loaded
• Top assembly hardware revision
• Installed options (if any).