Fluke 990DSL - Operating the Tester in Edit Mode

Setting Up and Operating the CopperPro
The Menus
3
3-9
Table 3-2. Operating the Tester in Edit Mode
If you want to Do this
Put the tester in Edit mode Press A(Edit).
Enter numbers, an asterisk
(*), or a pound sign (#)
Type the values directly from the keypad by
pressing the number keys, asterisk (*), or
pound sign (#).
Enter alphabetic characters Press > to put the tester in alphabetic text
entry mode. Then, press the key with the
desired alphabetic character. Keep pressing
the key until the desired alphabetic character
is displayed.
Exit alphabetic text entry
mode and return to numeric
entry mode
Press >.
Move the cursor forward one
position without changing the
displayed character
Press G.
Move the cursor backward
one position without changing
the displayed character
Press I.
Move the cursor back one
position and overwrite the
previous character
Press M.
Exit Edit mode and save the
changes
Press L.
Exit Edit mode, without
saving the changes
Press A(Edit).
Restore factory default setup
values
Press D(Restore Defaults).